English

Product Product

Product

Sibo has focused on potentiometers and sensors for 31 years.

FCP12A
FCP12A

FCP12A

1-turn Conductive Plastic POT.

    Characteristics:

  • Conductive Plastic

  • Servomount

  • RoHS Compliant

Dimension

FCP12A(图1)

Parameter

General Mechanical Specifications

Mechanical travel

360º(Endless)

Protection grade (IP)

IP40

Starting torque

≤1mN·m(10gf·cm)

Rotational life expectancy

25℃, No load at 400 r.p.m., inverting every 15 minutes 10,000,000 shaft revolutions, Total resistance value variation:≤±10% against initial value,Independent Iinearity tolerance:≤150% of specified value, Output smoothness: within 150% of specified value.

Mass

Approx.5g

Housing material

Aluminum

Environmental Specifications

Operating temperature range

-55℃~+105℃

Temperature cycle

5 cycles under -55℃~+105℃, total resistance value variation: ≤±10%, No mechanical damage.

Exposure at low temperature

24 hours at -55℃, Total resistance value variation: ≤±5%, No mechanical damage.

Exposure at high temperature

1,000 hours at 105℃, Total resistance value variation: ≤±10%, No mechanical damage.

Vibration

10Hz~2000Hz, 147m/s², 12 hours, Total resistance value variation: ≤±2%, No mechanical and electrical damage.

Shock

490m/s², 11ms, 18 times, Total resistance value variation: ≤±1%, No mechanical and electrical damage.

Moisture resistance

40℃, 95%RH, 120 hours, Total resistance value variation: ≤±10%,Insulation resistance: ≥10MΩ.

Resistance temperature coefficient

±400p.p.m./°C

General Electrical Specifications

Standard resistance values

1k, 2k, 5k, 10k(Ω)

Special practical resistance values

500, 20k, 50k, 100k(Ω)

Total resistance tolerance

Standard class ±15%(L),Precision class ±10%(K)

Independent linearity tolerance

Standard class ±2.0%,Precision class ±1.0%

Resolution

Essentially infinite

Output smoothness

≤0.1% against input voltage

Contact resistance variation

≤3%C.R.V.

Electrical travel

300°±5°

Power rating

0.2W

Insulation resistance

≥1000MΩ (500V.D.C.)

Dielectric strength

500V.A.C./1 min

Special Specifications Available

Special shaft type

Shaft with front and rear extension (Rear shaft with 1mm dia. and 10mm length), shaft dia. (φ3.175mm) with inch dimension, special machining on the shaft

Special electrical travel

Special electrical travel

Extra tap

Extra tap (Available up to 1 tap)

With stopper

With stopper (Rotating angle is

Special protection grade (IP)

310°and stopper strength is 0.3N・m [3kgf・cm])