English

Product Product

Product

Sibo has focused on potentiometers and sensors for 31 years.

FCP30A
FCP30A

FCP30A

1-turn Conductive Plastic POT.

    Characteristics:

  • Conductive Plastic

  • Servomount

  • RoHS Compliant

Dimension

FCP30A(图1)

Parameter

General Mechanical Specifications

Mechanical travel

360º(Endless)

Protection grade (IP)

IP40

Starting torque

≤2mN·m(20gf·cm)

Rotational life expectancy

25℃, No load at 400 r.p.m., inverting every 15 minutes 50,000,000 shaft revolutions, Total resistance value variation:

Mass

≤±10% against initial value,Independent Iinearity tolerance:≤150% of specified value, Output smoothness: within 150% of specified value.

Housing material

Approx.25g

Environmental Specifications

Operating temperature range

-55℃~+125℃

Temperature cycle

5 cycles under -55℃~+125℃, total resistance value variation: ≤±10%, No mechanical damage.

Exposure at low temperature

24 hours at -55℃, Total resistance value variation: ≤±5%, No mechanical damage.

Exposure at high temperature

1,000 hours at 125℃, Total resistance value variation: ≤±10%, No mechanical damage.

Vibration

10Hz~2000Hz, 147m/s², 12 hours, Total resistance value variation: ≤±2%, No mechanical and electrical damage.

Shock

490m/s², 11ms, 18 times, Total resistance value variation: ≤±1%, No mechanical and electrical damage.

Moisture resistance

40℃, 95%RH, 120 hours, Total resistance value variation: ≤±10%,Insulation resistance: ≥10MΩ.

Resistance temperature coefficient

±400p.p.m./°C

General Electrical Specifications

Standard resistance values

1k, 2k, 5k, 10k(Ω)

Special practical resistance values

500, 20k, 50k, 100k(Ω)

Total resistance tolerance

Standard class ±10%(K)

Independent linearity tolerance

Standard class ±1.0%,

Resolution

Precision class ±0.5%,

Output smoothness

Super precision class ±0.2%"

Contact resistance variation

Essentially infinite

Electrical travel

≤0.1% against input voltage

Power rating

≤2%C.R.V.

Insulation resistance

340°±5°

Dielectric strength

1.5W

Special Specifications Available

Special shaft type

Shaft with front and rear extension (Rear shaft with 3mm dia. and 10mm length), shaft dia. (φ3.175mm) with inch dimension, special machining on the shaft

Special electrical travel

Special electrical travel

Extra tap

Extra tap (Available up to 1 tap)

With stopper

With stopper (Rotating angle is

Multi-ganged

Up to 5 gangs, housing length is extended by 8.5mm per gang

Special protection grade (IP)

IP54