English

Product Product

Product

Sibo has focused on potentiometers and sensors for 31 years.

FCP50A
FCP50A

FCP50A

1-turn Conductive Plastic POT.

    Characteristics:

  • Conductive Plastic

  • Servomount

  • RoHS Compliant

Dimension

FCP50A(图1)

Parameter

General Mechanical Specifications

Mechanical travel

360º(Endless)

Protection grade (IP)

IP40

Starting torque

≤4mN·m(40gf·cm)

Rotational life expectancy

25℃, No load at 400 r.p.m., inverting every 15 minutes 50,000,000 shaft revolutions, Total resistance value variation:

Mass

≤±10% against initial value,Independent Iinearity tolerance:≤150% of specified value, Output smoothness: within 150% of specified value.

Housing material

Approx.70g

Environmental Specifications

Operating temperature range

-55℃~+125℃

Temperature cycle

5 cycles under -55℃~+125℃, total resistance value variation: ≤±10%, No mechanical damage.

Exposure at low temperature

24 hours at -55℃, Total resistance value variation: ≤±5%, No mechanical damage.

Exposure at high temperature

1,000 hours at 125℃, Total resistance value variation: ≤±10%, No mechanical damage.

Vibration

10Hz~2000Hz, 147m/s², 12 hours, Total resistance value variation: ≤±2%, No mechanical and electrical damage.

Shock

490m/s², 11ms, 18 times, Total resistance value variation: ≤±1%, No mechanical and electrical damage.

Moisture resistance

40℃, 95%RH, 120 hours, Total resistance value variation: ≤±10%,Insulation resistance: ≥10MΩ.

Resistance temperature coefficient

±400p.p.m./°C

General Electrical Specifications

Standard resistance values

1k, 2k, 5k, 10k(Ω)

Special practical resistance values

500, 20k, 50k, 100k, 200k, 500k(Ω)

Total resistance tolerance

Standard class ±10%(K)

Independent linearity tolerance

Standard class ±0.5%,Precision class ±0.2%,Super precision class ±0.05%"

Resolution

Essentially infinite

Output smoothness

≤0.1% against input voltage

Contact resistance variation

≤2%C.R.V.

Electrical travel

350°±5°

Power rating

3.0W

Insulation resistance

≥1000MΩ (1000V.D.C.)

Dielectric strength

1000V.A.C./1 min

Special Specifications Available

Special shaft type

Shaft with front and rear extension (Rear shaft with 6mm dia. and 15mm length), shaft dia. (φ6.35mm) with inch dimension, special machining on the shaft

Special electrical travel

Special electrical travel

Extra tap

Extra taps (Available up to 3 taps)

With stopper

With stopper (Rotating angle is 320° and stopper strength is 0.9N・m [9kgf・cm]) 

Multi-ganged

Up to 7 gangs, housing length is extended by 12mm per gang

Special protection grade (IP)

IP54