English

Product Product

Product

Sibo has focused on potentiometers and sensors for 31 years.

CP22
CP22

CP22

1-turn Wire-wound POT.

    Characteristics:

  • Wirewound

  • Servomount

  • RoHS Compliant

Dimension

CP22(图1)

Parameter

General Mechanical Specifications

Mechanical travel

360º(Endless)

Protection grade (IP)

IP40

Starting torque

≤1.5mN·m(15gf·cm)

Rotational life expectancy

25℃, No load at 40 r.p.m.1,000,000 shaft revolutions, Total resistance value variation:≤±5% against initial value,Independent Iinearity tolerance:≤150% of specified value, Noise:≤500Ω E.N.R.

Mass

Approx.15g

Housing material

Aluminum

Environmental Specifications

Operating temperature range

-55℃~+105℃

Temperature cycle

5 cycles under -55℃~+105℃, total resistance value variation: ≤±5%, No mechanical damage.

Exposure at low temperature

24 hours at -55℃, Total resistance value variation: ≤±5%, No mechanical damage.

Exposure at high temperature

1,000 hours at 105℃, Total resistance value variation: ≤±5%, No mechanical damage.

Vibration

10Hz~2000Hz, 147m/s², 12 hours, Total resistance value variation: ≤±5%, No mechanical and electrical damage.

Shock

490m/s², 11ms, 18 times, Total resistance value variation: ≤±1%, No mechanical and electrical damage.

Moisture resistance

40℃, 95%RH, 240 hours, Total resistance value variation: ≤±10%,Insulation resistance: ≥10MΩ.

Resistance temperature coefficient

±20p.p.m./°C

General Electrical Specifications

Standard resistance range

50Ω~10kΩ

Max. practical resistance value

20kΩ

Total resistance tolerance

Standard class ±3%(H),Precision class ±1%(F)

Independent linearity tolerance

Standard class ±0.5%,Precision class ±0.2%(≤1kΩ, ±0.3%)

Electrical travel

355°±5°

Power rating

0.5W

Insulation resistance

≥1000MΩ(1000V.D.C.)

Dielectric strength

1000V.A.C./1 min

Noise

≤100ΩE.N.R.

Standard resistance values

Resistance value (Ω)

50;100;200;500;1k;2k;5k;10k;*20k

No. of wire turns

300;370;470;450;570;740;1000;1270;1670

Resist. wire used

Cu-Ni;Ni-Cr

Special Specifications Available

Special resistance value

Lower resistance values (10Ω , 20Ω )

Special shaft type

Shaft with front and rear extension (Rear shaft with 3mm dia. and 10mm length), shaft dia. (φ3.175mm) with inch dimension, special machining on the shaft

Special electrical travel

Special electrical travel

Extra tap

Extra taps (Available up to 2 taps)

With stopper

With stopper (Rotating angle is

Multi-ganged

330° and stopper strength is 0.3N・m [3kgf・cm]) 

Special protection grade (IP)

Up to 5 gangs. Housing length is extended by 8.5mm per gang.